Packet data access points
Select
Menu
>
Ctrl. panel
>
Settings
and
Connection
>
Destinations
>
Access
point
, and follow the instructions on the display. Or, open one of the access point
groups, and select an access point marked with
.
Use the instructions provided by your service provider to edit the following:
Access point name — The access point name is provided by your service provider.
User name — The user name may be needed to make a data connection, and is usually
provided by your service provider.
Prompt password — If you want to set the device to ask for a password every time
you log in to a server, or if you do not want to save your password in the device, select
Yes
.
Password — A password may be needed to make a data connection and is usually
provided by your service provider.
Authentication — Select
Secure
to always send your password encrypted or
Normal
to send your password encrypted when possible.
Homepage — Depending on the access point type you are setting up, enter the web
address or the address of the multimedia message centre.
Use access point — Select
After confirmation
to set the device to ask for confirmation
before the connection using this access point is created, or
Automatically
to set the
device to connect to the destination using this access point automatically.
Select
Options
>
Advanced settings
and from the following:
Network type — Select the internet protocol type to transfer data to and from your
device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
DNS addresses — Enter the IP addresses of the primary and secondary DNS servers, if
required by your service provider. To obtain these addresses, contact your internet
service provider.
Proxy server address — Enter the address of the proxy server.
Proxy port number — Enter the port number of the proxy server.